User guide

Situation:
Handle and Cable Operated Mechanism turns ON, but disconnect switch does not transition to ON.
Adjustment:
Loosen the lifting washer
/ nut while tightening the washer / l ockwasher / nut, two or three turns should be sufficient (see Figure 1-5).
Check the OFF position of the actuator mechanism, that the lifting nut and sleeve of cable do not come into contact
with the bulkhead connector (Figure 1-5). If they do, move bulkhead connectors accordingly.
Situation:
Handle and Cable Operated Mechanism turns OFF, but disconnect switch does not transition to OFF.
Adjustment:
For the Cable Operated Disconnect Mechanism, loosen the washer
/ lock-washer / nut until the Disconnect Switch turns OFF with
positive action. Tighten both nuts and recheck for ON and OFF positions (Figure 1-5).
Be certain after adjustment to have a minimum of 1 thread past the washer
/ l ockwasher / nut assembly (Figure 1-5).
If any other adjustment problems should arise, contact your local Allen-Bradley representative.
Figure 1-5 Cable Operated Disconnect Mechanism
Adjustment Checklist
Dimensions
6.891
4.300
5.590
ø .210
5.990
(3)
Washer / Lockwasher / Nut
Tighten to 40 - 45 lb-in
Lifting Washer / Nut
Bulkhead Connector
Tighten to 65 - 70 lb-in
Slider
ATTENTION: Before any installation or maintenance is performed, make sure that the disconnect switch is not energized.
NOTICE
NOTICE