Owner manual

Publication 193-UM006A-EN-P – October 2005
B-14 DeviceNet Information
The following common services are implemented for the Parameter Group
Object:
Control Supervisor Object — CLASS CODE 0x0029
No class attributes are supported for the Control Supervisor Object. A single
instance (instance 1) of the Control Supervisor Object is supported. The
following instance attributes are supported.
Table B.34 Parameter Group Object Common Services
Service
Code
Implemented for:
Service Name
Class Instance
0x0E Yes Yes Get_Attribute_Single
Table B.35 Control Supervisor Object Instance Attributes
Attribute
ID
Access Rule Name Data Type Value
10 Get Tripped BOOL 0=No Fault present
1= Fault Latched
11 Get Warning BOOL 0=No Warning Present
1=Warning present (not latched)
12 Get/Set Fault Reset BOOL 1…>1=Trip Reset; otherwise no action
13 Get Trip Code UINT ODVA TRip Code—In trip state indicates cause of trip; if not tripped,
indicates cause of last trip.
14 Get Warning Code UINT ODVA Warning Code—In warning state indicates cause of warning;
if no warning, indicates cause of last warning.
100 Get Trip Status WORD Bit 0=Overload
Bit 1=Phase Loss
Bit 2=Jam
Bit 3=Not Used
Bit 4=Not Used
BIt 5=Not Used
Bit 6=Not Used
Bit 7=Not Used
101 Get Warning Status WORD Bit 0=Overload
Bit 1=Not Used
Bit 2=Jam
Bit 3=Underload
Bit 4=Not Used
BIt 5=Comm Fault
Bit 6=Comm Idle
Bit 7=EEPROM
102 Get Trip Lob 0 WORD Last trip condition. Bit definitions of the value are the same as
attribute 114.
103 Get Trip Log 1 WORD Last trip condition. Bit definitions of the value are the same as
attribute 114.