User Manual

Rockwell Automation Publication 193-UM002I-EN-P - December 2011 269

Appendix

CE Compliance

The E3 Overload Relay is intended for use in a heavy industrial environment. It is

CE marked for conformity to the Low Voltage Directive 73/23/EEC (as

amended by 93/68/EEC) and the EMC Directive 89/336/EEC (as amended by

92/31/EEC and 93/68/EEC) when installed as described in this manual.

EC Directive Compliance

To obtain a copy of the E3 Overload Relay’s Declaration of Conformity (DoC),

contact your local Rockwell Automation sales office or Allen-Bradley distributor

or go to http://www.ab.com/certification/#CEmark.

EMC Directive

This product is tested to meet Electromagnetic Compatibility (EMC) Directive

89/336/EC, as amended by 92/31/EEC and 93/68/EEC, by applying the

following standards (in whole or in part), and as documented in a technical

construction file:

• EN 60947-4-1 – Low Voltage Switchgear and Control Gear; Part 4 –

Contactors and Motor Starters, Section 1 – Electromechanical Contactors

and Motor Starters

• EN 60947-5-1 – Low Voltage Switchgear and Control Gear; Part 5 –

Control Circuit Devices and Switching Devices, Section 1 –

Electromechanical Control Circuit Devices

IMPORTANT

The conformity of the E3 Overload Relay to these standards does not

guarantee that an entire installation will conform. Many other factors

can influence the entire installation and only direct measurements can

verify total system conformity. It is therefore the responsibility if the

installer to ensure system conformity.

IMPORTANT

The grounding requirements specified in this manual must be followed by

the installer in order for the product to comply with the EMC directive.

ATTENTION: This is a Class A (heavy industrial) product. In a Class B

(light industrial or domestic) environment, this product may cause radio

interference in which case the installer may be required to take additional

measures to mitigate it.