User Manual

144 Rockwell Automation Publication 193-UM002I-EN-P - December 2011
Chapter 6 Monitoring Parameters
Firmware
This parameter allows the installer to read
the firmware revision number (FRN) of the
E3 Overload Relay.
Parameter Number 22
Access Rule Get
Data Type UINT
Object Mapping B4hex-01-0C
Group Monitor
Units —
Minimum Value 0
Maximum Value 65535
Default Value —
Dev Config
This parameter allows the installer to read
which features are enabled in the E3
Overload Relay as outlined in the table
below:
1 = On or Present
0 = Off or Not Present
Parameter Number 23
Access Rule Get
Data Type UINT
Object Mapping B4hex-01-14
Group Monitor
Units —
Minimum Value —
Maximum Value —
Default Value —
Bit Function:
1514131211109876543210
X4 in/2 out
X PTC Hardware
X GF Hardware
XExternal GF
XHeat Trace
XVoltage Hdw
Warn Log 0 (Series C and later)
This parameter records the latest warning.
Parameter Number 90
Access Rule Get
Data Type WORD
Object Mapping 29hex-1-109
Group Monitor
Units —
Minimum Value See Warning Status Table
Maximum Value See Warning Status Table
Default Value 0
Warn Log 1 (Series C and later)
This parameter records the warning
previous to Warn Log 0.
Parameter Number 91
Access Rule Get
Data Type WORD
Object Mapping 29hex-1-110
Group Monitor
Units —
Minimum Value See Warning Status Table
Maximum Value See Warning Status Table
Default Value 0