User Manual

124 Rockwell Automation Publication 193-UM002I-EN-P - December 2011
Chapter 5 Programmable Parameters
Table 60 - Other Reset/Test Lock Group Parameters Detail
RESET MAX kVA DMND
This parameter allows the installer to reset
the maximum kVA Demand parameter to
zero.
Parameter Number 298
Access Rule Get/Set
Data Type BOOL
Object Mapping 0Fhex-12A-01
Group Reset/Lock
Units —
Minimum Value 0 = No Action
Maximum Value 1 = Reset
Default Value 0
TRIP RESET
This parameter provides the user with the
capability of resetting a trip over the
DeviceNet network. After a trip is reset, the
parameter automatically returns to a
“Ready” state.
Parameter Number 26
Access Rule Get/Set
Data Type BOOL
Object Mapping 0x29-1-126
Group Reset/Lock
Units —
Minimum Value 0 = Ready
Maximum Value 1 = Reset
Default Value 0
PROGRAM LOCK
This parameter prohibits the device
parameters from being altered when set to
“Locked”.
This parameter must be set to “Unlocked”
to allow parameter modification.
Parameter Number 53
Access Rule Get/Set
Data Type BOOL
Object Mapping 0xB4-1-18
Group Reset/Lock
Units —
Minimum Value 0 = Unlocked
Maximum Value 1 = Locked
Default Value 0
SET TO DEFAULTS
This parameter allows the user to reset the
parameter settings to the factory default
values. After parameter values have been
reset to the factory default settings, the
parameter automatically returns to a
“Ready” state.
Parameter Number 54
Access Rule Get/Set
Data Type BOOL
Object Mapping 0xB4-1-19
Group Reset/Lock
Units —
Minimum Value 0 = Ready
Maximum Value 1 = Set
Default Value 0
TEST ENABLE (Series C and later)
This parameter allows the installer to
enable or disable the test function of the
Test/Reset button.
Parameter Number 103
Access Rule Get/Set
Data Type BOOL
Object Mapping 29hex-1-108
Group Reset/Lock
Units —
Minimum Value 0 = Disable
Maximum Value 1 = Enable
Default Value 1