Quick Start Manual

Rockwell Automation Publication IASIMP-QS019E-EN-P - August 2013 289
Controller, Network, and Device Configuration Without the DMAT Wizard Appendix G
The Speed Reference wizard step opens.
13. Set the Speed Reference parameters
appropriate for your application and drive
hardware.
14. Continue to Click Next until you reach the Applied and Pending Changes wizard step.
All applied and pending changes are listed.
15. Click to print your list of changes.
16. Click Finish to accept the changes.
17. Click OK in the Module Properties dialog box to save the drive configuration.
18. Click to save your Logix Designer application file.
TIP
The drive speed reference parameter is automatically set when Use Network Reference is checked in the Module Definition
dialog box. Refer to step 8
on page 282.