Quick Start Manual

Rockwell Automation Publication IASIMP-QS019E-EN-P - August 2013 277
Controller, Network, and Device Configuration Without the DMAT Wizard Appendix G
Device Configuration
In this section you configure your Drives and Motion hardware by using the Logix Designer application and
MotionView OnBoard software.
To assist you in device configuration, the Widg-O-matic machine application example is referenced in the device
configuration steps. Two servo drives are configured for the X-Y gantry assembly section, one PowerFlex drive is
configured for the conveyor, and one Kinetix 300 drive is configured for the packaging diverter.
Widg-O-matic Machine Application Example
PowerFlex Drive Configuration
PowerFlex drive configuration applies to all 4-class and 7-class drives and includes these procedures:
• Update PowerFlex Add-On Profiles
• Add and Configure PowerFlex Drives
• Set PowerFlex Drive Parameters
• Download Drive Parameters
755
00
3
00
Conveyor
Y-Servo
X-Servo
X-Y Gantry
Kinetix 6500
Drives
Diverter
Kinetix 300
Drive
PowerFlex 753
Drive
S
e
r
v
o
M
o
t
o
r
D
r
i
v
e
n
E
l
e
c
t
r
i
c
C
y
l
i
nde
r
I
n
d
u
c
t
i
o
n
M
ot
o
r
Assembly
Packaging