Quick Start Manual

Rockwell Automation Publication IASIMP-QS019E-EN-P - August 2013 275
Controller, Network, and Device Configuration Without the DMAT Wizard Appendix G
The New Module dialog box opens.
4. Configure the new module.
a. Type the module Name.
b. Enter the Logix5000 sercos module slot
(leftmost slot = 0).
c. Check Open Module Properties.
5. Click OK.
Your new module appears under the I/O
Configuration folder in the Controller
Organizer.
6. Click the SERCOS Interface tab and
reference the Sercos Data Rate table.
Sercos Data Rate
7. From the Data Rate pull-down menu, match the DIP switch setting on the drive module or choose Auto
Detect.
Logix5000 Sercos Module Number of Axes Data Rate
1756-M03SE Up to 3
4 or 8 Mbps
1756-M08SE Up to 8
1756-M16SE Up to 16
1768-M04SE Up to 4