Quick Start Manual

Rockwell Automation Publication IASIMP-QS019E-EN-P - August 2013 269
Appendix G
Controller, Network, and Device Configuration
Without the DMAT Wizard
In this appendix you configure your controller, network, and device hardware; then import the machine,
application, and device modules into your Logix Designer application without using the DMAT Wizard or
making edits after the initial file is created.
Before You Begin
• Complete your system architecture and hardware selection (refer to Chapter 1 and Appendix E).
• Complete your system layout and wiring (refer to Chapter 3 and Appendix F).
What You Need
• The Drives and Motion Accelerator Toolkit DVD, publication IASIMP-SP017. For a copy of the DVD,
contact your local Rockwell Automation distributor or sales representative.
• RSLogix 5000 software, version 18.0 or later, or the Logix Designer application, version 21.0 or later, for
Kinetix 300, Kinetix 6500, PowerFlex 753, and PowerFlex 525 drives.
• RSLogix 5000 software, version 19.0 or later, or the Logix Designer application, version 21.0 or later, for
PowerFlex 755 CIP Motion drives.
• RSLogix 5000 software, version 20.0 or later, or the Logix Designer application, version 21.0 or later, for
Kinetix 350 servo drives.
• Sercos and Analog Motion Configuration and Startup User Manual, publication MOTION-UM001
• CIP Motion Configuration and Startup User Manual, publication MOTION-UM003
• ControlFLASH Firmware Upgrade Kit Quick Start, publication 1756-QS105
• The user manual for your Drives and Motion hardware. Refer to Additional Resources on page 15 for
publication numbers.