Quick Start Manual

266 Rockwell Automation Publication IASIMP-QS019E-EN-P - August 2013
Appendix F Assemble Project Drawing Set Without the DMAT Wizard
4. Paste the enclosure layout drawing into your Project
Drawings folder.
5. Double-click the 02_Subpanel_Layouts folder and
open either the Large (Approx. 56”x 56”) or Small
(57”x 33”) subpanel folder based on your enclosure
selection and system subpanel needs.
For the Widg-O-matic machine application
example, the Small subpanel folder was selected.
6. Right-click the appropriate drawing, based on the
Subpanel Selection Layout table, and choose Copy.
Subpanel Selection Layout
For the Widg-O-matic machine application example, the 150_CLX_w_LIM_Sm_Panel_Layout.dwg file
was selected.
Logix5000 Controller Family Power Distribution Layout Sub-panel Drawing
ControlLogix or GuardLogix
Controllers
LIM module for three-phase/control power distribution 150_CLX_w_LIM_xx_Panel_Layout.xxx
Traditional three-phase/control power distribution components 150_CLX_wo_LIM_xx_Panel_Layout.xxx
CompactLogix or Compact
GuardLogix Controllers
LIM module for three-phase/control power distribution 150_CMLX_w_LIM_xx_Panel_Layout.xxx
Traditional three-phase/control power distribution components 150_CMLX_wo_LIM_xx_Panel_Layout.xxx