Quick Start Manual

262 Rockwell Automation Publication IASIMP-QS019E-EN-P - August 2013
Appendix F Assemble Project Drawing Set Without the DMAT Wizard
4. Paste the drawings into your Project Drawings folder.
5. Repeat step 2…step 4 for every drive in your system with safety
options.
For the Widg-O-matic machine application example, the following
drive I/O drawings were copied to accommodate the two
Kinetix 6500 servo drives, one PowerFlex 753 drive, and one
Kinetix 300 drive.
Select Controller I/O Drawings
1. Navigate to the desired (DWG, DXF, or PDF) file type folder on the toolkit DVD and select Controller
I/O Section.
2. Double-click the folder matching your Controller I/O.
For the Widg-O-matic machine application
example, the 1756_IO_CLX_GLX folder was
selected supporting the 1756 ControlLogix
controller I/O modules.