Quick Start Manual

260 Rockwell Automation Publication IASIMP-QS019E-EN-P - August 2013
Appendix F Assemble Project Drawing Set Without the DMAT Wizard
4. Paste the drawing into your Project Drawings folder.
For the Widg-O-matic machine application
example, the 030_CLX_GLX_120VAC_Control
Power.dwg file was copied to accommodate the
ControlLogix controller.
5. Repeat step 2…step 4 for every controller family in
your system.
Select External Safety Relay Option Drawings
1. Navigate to the desired (DWG, DXF,
or PDF) file type folder on the toolkit
DVD and select Safety Section.
2. Copy the External Safety Relay
Option drawings for your specific
system hardware.
For the Widg-O-matic machine application example, no external safety drawings were selected because the
built-in drive safety I/O was used.