Quick Start Manual

246 Rockwell Automation Publication IASIMP-QS019E-EN-P - August 2013
Appendix E Create and Add BOM Device Modules Without the DMAT Wizard
Follow These Steps
Complete the following steps to create a bill of materials and size your drives and motion system components.
Select Initial BOM Files
Follow these steps to select your initial BOM files.
1. Open and rename the initial ProposalWorks BOM file.
a. Navigate to and select the appropriate voltage class directory, based on your system power voltage,
within the BOM development folder.
For the Widg-O-matic example, 400 VAC Class directory is selected.
The Voltage Class System Start folder opens.
Add BOM Device Modules
page 248
Select Initial BOM Files
page 246
Start