Quick Start Manual

242 Rockwell Automation Publication IASIMP-QS019E-EN-P - August 2013
Appendix D Logix Designer Communication and Controller Configuration
3. Double-click a request from one of the devices.
4. Enter a unique IP address for each device.
5. Click OK.
If you are not on an isolated network, obtain the IP addresses from your network administrator.
6. Repeat step 3…step 5 for each device, except the PanelView Plus terminal.
7. Select the first device in the Relation List field.
8. Click Disable BOOTP/DHCP.
9. Repeat step 7…step 8 for all devices except the PanelView Plus terminal.
10. Close the BOOTP/DHCP utility.
If prompted to save changes, click No.
IMPORTANT
If you cycle power, the device will not retain its IP address unless you disable BOOTP/DHCP.