Quick Start Manual

Rockwell Automation Publication IASIMP-QS019E-EN-P - August 2013 241
Logix Designer Communication and Controller Configuration Appendix D
Assign IP Addresses
The BOOTP/DHCP Server utility is used to assign IP addresses to most devices in this quick start, except the
PanelView Plus terminal. The BOOTP/DHCP utility is installed during the Logix Designer application
installation.
1. From the Start menu, launch the BOOTP/DHCP Server utility.
If you are running this utility for the first time, the
Network Setup Error dialog box opens.
a. Click OK.
b. Enter the subnet mask from step 7 on page 235.
If you are not running this utility for the first time,
select Tools>Network Settings.
2. Click OK.
The Request History field displays all devices in your
network that need IP addresses.
The EtherNet/IP (MAC) addresses correspond to the
pre-loaded addresses and typically are marked on the
device labels.