Quick Start Manual

Rockwell Automation Publication IASIMP-QS019E-EN-P - August 2013 17
Chapter 1
Initial System Configuration Using the DMAT Wizard
In this chapter you use the Drives and Motion Accelerator Toolkit (DMAT) Wizard to create an initial bill of
materials, assemble a system drawing set, and create a Studio 5000 Logix Designer project file with a
preconfigured controller, network, drives and initial system program logic. In addition, you are introduced to
several Rockwell Automation system configuration tools that provide assistance in sizing your motor/drive
combinations for a variety of load, transmission, and application types.
To assist you in architecture and hardware selection, the Widg-O-matic machine application is referenced in the
selection steps. Hardware selection includes all power and control equipment to support two servo drives for the
X-Y gantry, one PowerFlex drive for the conveyor, and one Kinetix 300 drive for the packaging diverter.
Widg-O-matic Machine Application Example
755
00
3
00
Conveyor
Y-Servo
X-Servo
X-Y Gantry
Kinetix 6500
Drives
Diverter
Kinetix 300
Drive
PowerFlex 753
Drive
S
e
r
v
o
M
o
t
o
r
D
r
i
v
e
n
E
l
e
c
t
r
i
c
C
y
l
i
nde
r
I
n
d
u
c
t
i
o
n
M
o
t
o
r
Assembly
Packaging