User Manual Instruction Manual

Rockwell Automation Publication 193-UM014B-EN-P December 2011 73
Chapter 9
Device Parameters
Introduction
The EtherNet/IP Communications Auxiliary provides parameters to allow the
user to view the status and configure the DeviceNet scanner with RSNetWorx for
DeviceNet if the user does not want to use the internal web server of the
EtherNet/IP Communications Auxiliary. The 14 available parameters are listed
below.
Table 8 - Parameter List
Parameter Programming
Parameter Listing
The details for each of the 14 available parameters are listed below.
Table 9 - Parameter 1 — Scanner Status
1 Scanner Status 8 SL Entry Size
2 SL Entry 1 Status 9 Device Keys
3 SL Entry 2 Status 10 Scanlist Config
4 SL Entry 3 Status 11 ADR Record
5 SL Entry 4 Status 12 ADR Enable
6 SL Entry 5 Status 13 DNet IO RPI
7 SL Entry 6 Status 14 DNet IO Inhibit
IMPORTANT
Parameter setting changes to the EtherNet/IP Communications Auxiliary
take effect immediately even during a “running” status.
Description Access Rule Data Type Units
Value
Min. Max. Default
Provides the status of the
Devicenet scanner.
Get WORD — 0 16383 0
Bit
0 On Line 3 No Scanner Messages 6 Initializing
1 Illegal Scan List 4 Transmit Failure 7 Duplicate MAC Failure
2 No Network Messages 5 In Idle Mode 8 Bus Off