User Manual Instruction Manual

Rockwell Automation Publication 193-UM014B-EN-P December 2011 69
Chapter 8
3. Log in with the username “Adminstrator”, leave the password field blank,
and click OK.
4. Type the information into the e-mail notification fields as stated below.
5. Check the desired notification time, fault conditions, and local conditions
to be included in notification e-mails to the recipient. These can be
changed after the initial configurations.
6. ClickApply Changes to save the configuration.
Configure Device Identity
The properties of the Device Identity populate the notification e-mail subject
and e-mail body. To configure the Device Identity, perform the following steps.
1. Select Administrative Settings>Device Identity.
NOTE: If desired, a password can be set within the Administrative Settings tab.
E-mail Recipient The e-mail address of the person who will receive the notifications.
E-Mail Sender The e-mail address from which the notification will be sent.
SMTP Server Consult with the network administrator for the SMTP server address.
SMTP Username Consult with the network administrator for the SMTP username.
SMTP Password Consult with the network administrator for the SMTP password.
SMTP Port Consult with the network administrator which SMTP port number to
use. Port 25 is the most common SMTP port.