User Manual Instruction Manual

Rockwell Automation Publication 193-UM014B-EN-P December 2011 31
Chapter 3
Configure the DeviceNet Network
Introduction
The purpose of this chapter is to assist in configuring the DeviceNet Network
with the EtherNet/IP Communications Auxiliary. A DeviceNet network can be
configured using the internal web interface from the EtherNet/IP
Communications Auxiliary.
Configuration
1. From the web page, navigate to Scan List>Configuration>Advanced.
2. If desired, change the baud rate using the DeviceNet Baud Rate pull-down
menu. The default value of 125K for the DeviceNet network.
NOTE: Autobaud is not supported with this product.