Owner manual
Chapter 1 –Introduction
1-4
Status
– OUT A ON/OFF
– OUT B ON/OFF
– Fault code
– Protection parameter values:
Parameter #1: Average Current
Parameter #2: FLC Setting
Parameter #3: Thermal Capacity Used
Parameter #4: Current Unbalance
– Additional parameter values (displayed on HIM only)
Parameter #5: SMP-3 Firmware Revision
Parameter #6: Device Port #
Parameter #7: Mask (0 = Disabled)
Parameter #8: Status
The SMP-3 overload relay can communicate the specified
status and control data to and from the following Human
Interface and Communication Modules:
Device Communicated Information
OUT A and B control functions
SMP-3 Human Interface
MHM
Display OUT A and B status ( HIM LEDs and HIM
display)
M
odule (
H
I
M
)
Display fault status (HIM LED and HIM display)
Monitor all SMP-3 parameters
OUT A control function only
Drive Human Interface
MHM
Display OUT A and B status (HIM display only)
Dr
ive
H
uman Inte
r
face
Module (HIM)
Display fault status (HIM display only)
Monitor all SMP-3 parameters
OUT A and B control functions
Bulletin 1203
M
Display OUT A and B status (on programmable log-
ic controller SIM LEDs [Cat. No. 1747-SIM] or
PanelView display)
B
ulletin 12
0
3
Communication Modules
Display fault status (on programmable logic control-
ler SIM LEDs [Cat. No. 1747-SIM] or PanelView
display)
Monitor SMP-3 protection parameters