Owner manual

Chapter 5 –Human Interface Module

5-6

ACTION

DESCRIPTION

HIM DISPLAY

ESC SEL

To Select Mode

1. Press any key to go from the Status Display to the Choose Mode

menu.

2. Press the up/down keys to toggle to “Display” in the display.

3. Press Enter to go to the Display menu. (If this is the first time that

the display mode is entered since the last power-up, the display will

start with parameter 1. Otherwise the display will start with the last

parameter displayed). The parameter number is located on the right

side of the value line.

4. Press Up for the next display parameter.

A=OXX B=OXX

X.X AMPS

Choose Mode

Display

Average Current

X.X AMPS 1

FLC Setting

X.X AMPS 2

Thermal Cap Used

X%TCU 3

Current Unbal

X%CU 4

(Firmware Rev?)

X.xx 5

DEVICE PORT#

00000XX0 6

MASK (0–DISABLE)

00000XX0 7

STATUS

XXXXXXX

XXXXXXX 8