Owner manual

Chapter 4 –Functional Description
4-11
Communication Parameters. (cont.)
[Mask]
The mask parameter can be used to program or
identify the communication adapter devices that are
enabled and/or disabled. Refer to Chapter 8 for
Logic Mask Programming instructions
Parameter # 7
Parameter Type Read/Write
Units Byte
Factory Default 00000110
Settings 1 Permit Control (enabled)
0 Deny Control (disabled)
Bit
A apter er
ett g
Epaat
7 6 5 4 3 2 1 0
A
d
apter
Numb
er
S
ett
in
g
E
x
p
l
a
n
at
ion
X Not Used — —
X Adapter 1
1
0
Enabled (Unmasked)
Disabled (Masked)
X Adapter 2
1
0
Enabled (Unmasked)
Disabled (Masked)
X Not Used — —
X Not Used — —
X Not Used — —
X Not Used — —
X Not Used — —
[Status]
This parameter is a 16 bit common status message
interpreted by the HIM and transmitted by all serial
port master devices. The message status contents
for the SMP-3 overload relay are defined in Table
4.A.
Parameter # 8
Parameter Type Read Only
Units