Owner manual

Chapter 4 –Functional Description
4-10
Communication Parameters. (cont.)
[Firmware Revision]
The firmware revision number identifies the release
of the logic code that is controlling the SMP-3
overload relay. If contacting the factor regarding a
problem, be prepared to provide this number.
Parameter # 5
Parameter Type Read Only
Units None
[Device Port #]
This parameter identifies the port that the adapter
being used to monitor the parameter is connected to.
The SMP-3 overload relay only supports port 1 and
port 2, identified by a “1” in the second or third
position from the right, respectively.
Parameter # 6
Parameter Type Read Only
Units Byte
Bit
Prt er
ett g
Epaat
7 6 5 4 3 2 1 0
P
o
rt
Numb
er
S
ett
in
g
E
x
p
l
a
n
at
ion
X Not Used — —
X Port 1 1 Connected
X Port 2 1 Connected
X Not Used — —
X Not Used — —
X Not Used — —
X Not Used — —
X Not Used — —