Owner manual

Chapter 3 –Installation and Wiring
3-2
ASSEMBLY OF SMP-3 OVERLOAD RELAY TO CONTACTOR
The following figures illustrate the steps necessary to assemble
the SMP-3 overload relay to a contactor.
Figure 3.1 Assembly of SMP-3 Overload Relay to Contactor (applicable to Cat. No. 193-C1_1 and Cat. No. 592-C1_T)
2.8 Nm
25 lb-in
Note: A Cat. No. 193-C1_1 or Cat. No. 592-C1_T must be
mounted to the contactor prior to fastening the contactor to a
panel.