Owner's manual

1901-UM020C-EN-P – June 2013
Setup and Commissioning Chapter 4
Setup ..................................................................................................... 4-1
Lithium Battery ............................................................................... 4-1
Analog Card DIP Switches ............................................................. 4-1
Programmer/Display DTAM .......................................................... 4-1
R
F1 and RF2 Resistor Setup ............................................................ 4-2
Commissioning ...................................................................................... 4-7
Programming the SyncPro Chapter 5
Set Points ............................................................................................... 5-1
Set Point 1 • Minimum % Synchronous Slip Frequency ................. 5-2
Set Point 2 • Power Factor Trip ...................................................... 5-2
Set Point 3 • Power Factor Trip Time Delay .................................. 5-2
Set Point 4 • Squirrel-Cage Protection Trip Time (at 95% speed) .... 5-3
Set Point 5 • Squirrel-Cage Protection Trip Time (at 50% speed) .... 5-3
Set Point 6 • Squirrel-Cage Protection Trip Time (at stall) ............ 5-3
Set Point 7 • Function Number ....................................................... 5-4
Set Point 8 • Incomplete Sequence Trip Time Delay ...................... 5-5
Set Point 9 • Diagnostic Fault Mask ............................................... 5-5
Additional Parameters............................................................................ 5-6
Monitoring Chapter 6
Power Factor.......................................................................................... 6-1
Faults ..................................................................................................... 6-1
Fault Detection and Diagnostics...................................................... 6-1
Power Factor Circuit Fault ............................................................. 6-2
Troubleshooting Chapter 7
Last Trip Codes • Table 7.A.................................................................. 7-1
Troubleshooting Guide • Table 7.B ....................................................... 7-2
Spare Parts Chapter 8
Spare Parts List for SyncPro ................................................................. 8-1
ii Table of Contents – SyncPro™ Instruction Manual