Installation Manual Manual

Publication CNET-IN003A-EN-P - January 2006
3-20 Install a ControlNet Ex Media System
Attach the Connectors to the Cable
1. Push the calibration/flare tool onto the cable and with a slight
twisting motion (with sufficient inward pressure) to expand the
braid.
IMPORTANT
Replace the trunk cable section if problems persist
with the cable after completing these tests.
41888
4189
0
Push the calibration/flare tool gently and
rotate slightly onto the connector while
you apply pressure. This will work the
base of the connector underneath
the wire braid slowly.