User Manual

14 FLEX Ex I/O 24V DC 4 Non-Isolated Source Output Module

Publication

1797-5.6 - June 2011

Repair

This module is not field-repairable. Any attempt to open this module will void

the warranty and IS certification. If repair is necessary, return this module to

the factory.

Alarm Filter These 3 bits are used to set the time constant of the fault/overload alarm

filter for channels 0…3.

Default = 0

Reset Alarms With this bit, wire off/overload fau

lts are reset and the latch condition of

the outputs cancelled. See Latch Alarms (LA). To reset the wire

off/overload faults set the RA bit to 1 and back to 0. The reset will not

occur until a 0 > 1 > 0 transition occurs.

RSLogix 5000 Software Tip: The Reset Alarms bit is found in the Module

nfiguration word. Program a Module Reconfigure typed MSG to set and

then clear the RA bit.

0 = Normal

1 = Reset

Default: 0

Field Descriptions

Value Binary Time constant

000 0.25 ms (Hardware)

001 0.5 ms

010 1 ms

011 2 ms

100 4 ms

101 8 ms

110 16 ms

111 32 ms