Installation Instructions

ControlNet Daughtercards 9
Publication 1788-IN005B-EN-P - October 2005
For more fiber cable options, refer to the ControlNet Fiber Media Planning and Installation
Guide, publication CNET-IN001.
Connect to the Network Using a Fiber Cable
1. Remove and save the protective caps from the ControlNet daughtercards.
2. Connect the fiber cable connector to the module’s connector.
Wire the Fiber Module for Zipcord Operation
The zipcord uses a duplex cable. Duplex cables use a single cable that contains two separate
fibers, one for transmit and one for receive.
IMPORTANT
To prevent inadvertent reversal of the trunk cable connections (resulting
in incorrect status displays), check the drop cable for a label indicating
the attached cable before you make your connection.
ATTENTION
Under certain conditions, viewing the optical port may expose the eye to
hazard. When viewed under some conditions, the optical port may expose
the eye beyond the maximum permissible exposure recommendations.
42821
1
2