Installation Instructions

8 ControlNet Daughtercards
Publication 1788-IN005B-EN-P - October 2005
Install the Card
Due to wide variation in available host devices, we cannot provide specific installation
instructions in this document. For instructions on how to install the daughtercard in a host
device, refer to the user manual for the particular host device.
Connect the Card to the Network
After you have installed the card, connect it to the network. You must connect the card to the
network using an approved ControlNet fiber cable such as:
WARNING
If you insert or remove the card while host power is on, an electrical arc
can occur. This could cause an explosion in hazardous location
installations. Be sure that power is removed or the area is nonhazardous
before proceeding.
IMPORTANT
Before you install your fiber-based network, refer to the ControlNet Fiber
Media Planning and Installation Guide, publication CNET-IN001.
Cable Assembly Cat. No.
10 m 1786-FS10
20 m 1786-FS20
60 m 1786-FS60
100 m 1786-FS100
200 m 1786-FS200
300 m 1786-FS300
42822
42823