User Manual User Manual

Publication DNET-UM003A-EN-P - August 2000
3-24 Connect Devices and Commission Nodes
Connect and Commission the ControlTower Stack Light
1. Assemble the ControlTower Stack Light. Refer to the instructions
provided with the device. For our demonstration, we placed the
red Stack Light on the top and the green on the bottom.
2. Set the node address by hand to 03.
Use tool provided with the ControlTower Stack Light to set these
switches and refer to the instructions provided with the device
for details.
3. Connect the ControlTower Stack Light to a KwikLink tap.
Your network should look like this:
4. You should see a quick blink of each Stack Light when you
connect to the network.
I-0
A-0
I-1
A-1
O-0
O-1
Auxiliary Power
Network Status
Module Status
01234567 01234567
Network
Status
Module
Status
T
T
To scanner and interface
42039