User Manual User Manual

Publication DNET-UM003A-EN-P - August 2000
3-4 Connect Devices and Commission Nodes
Prepare to Add Nodes
At this point you should have read and performed tasks in Chapters 1
& 2. Review your checklist from Chapter 1. You should have:
• read about a DeviceNet network
• identified, organized and secured what you need to use this
Starter Kit
• located Rockwell Automation support services
• assembled the KwikLink media
• connected the ArmorBlock MaXum I/O base to the KwikLink
media and attached the seal block
• connected and grounded your power supply
• installed the scanner into your chassis
• connected your interface
• installed the required software drivers for PC cards
• connected your PC
• installed the Demo Version of RSNetWorx for DeviceNet