Installation Instructions

1787-5.8 - February 1999

DeviceNet Power Supply

Catalog Number 1787-DNPS

Use this document as a guide when you install a DeviceNet™ Power

Supply (model number CP680).

About the Power Supply

:HGHVLJQHGWKH'HYLFH1HWSRZHUVXSSO\VSHFLILFDOO\IRU'HYLFH1HW

QHWZRUNV,WFRQIRUPVWRDOODSSOLFDEOHQDWLRQDOHOHFWULFFRGHV

The power supply provides the following features:

• standard IEC 3-pin connector

• main power switch with a dual-voltage selection switch

• standard DeviceNet 5-pin open style connector

• stud for earth to ground connection

• green LED power indicator

• stud for earth-to-ground connection

European Union

Directive Compliance

If this product bears the marking, it is approved for installation within

the European Union and EEA regions. It has been designed and tested to

meet the following directives.

EMC Directive

This product is tested to meet Council Directive 89/336/EEC

Electromagnetic Compatibility (EMC) and the following standards, in

whole or in part, documented in a technical construction file:

• EN 50081-2EMC - Generic Emission Standard, Part 2 - Industrial

Environment

•

ΕN 50082-2EMC - Generic Immunity Standard, Part 2 - Industrial

Environment

This product is intended for use in an industrial environment.

Low Voltage Directive

This product is tested to meet Council Directive 73/23/EEC Low Voltage,

by applying the safety requirements of EN 61131-2 Programmable

Controllers, Part 2 - Equipment Requirements and Tests.

PAGE 1
Installation Instructions DeviceNet Power Supply Catalog Number 1787-DNPS Use this document as a guide when you install a DeviceNet™ Power Supply (model number CP680).
PAGE 2
DeviceNet Power Supply For specific information on the power supply requirements, see the appropriate sections in this manual as well as the following Allen-Bradley publications: • Industrial Automation Wiring and Ground Guidelines, publication 1770-4.1 • Automation Systems Catalog, publication B111 This equipment is classified as open equipment and must be installed (mounted) in an enclosure during operation as a means of providing safety protection.
PAGE 3
DeviceNet Power Supply 3 3. Secure all necessary cords from the DeviceNet network in their appropriate ports once the power supply is securely mounted. ATTENTION: For alternate usage at an input of 230V ac operation, the cord must be “SVT” type or equivalent with an IEC320-C13 connector and appropriate grounded plug. Cord must be 1.8m to 3.0m in length and rated for 2500W (250V/10A). Be certain that the voltage selection switch is set for proper input voltage before application of main power. 4.
PAGE 4
Table 1: Specifications Power Connector 3-pin IEC Line Frequency 48-62 Hz Fuse Class 2 type accepted1 Turn-on Time (with full load) 250msec max 95% of final value Size 5” x 6.5” x 11” Isolation output isolated from AC and chassis ground DC Connector Phoenix Combicon style 5-pin 5.