Installation Instructions Owner manual

10 ControlNet Coax Taps
Rockwell Automation Publication 1786-IN007C-EN-P - October 2010
Mount to Surface or Fixture
To mount the tap to a surface or fixture, complete steps 1…5 described in the
section Mount to DIN Rail (on page 7), and then complete these steps.
1. If needed, pre-drill holes into the surface that align with holes in the
outer corners of the universal mounting bracket.
The holes of the universal mounting bracket have a diameter of 4.3 mm
(0 .17 in.).
2. Place the universal mounting bracket against the surface and insert four
screws (not included) into the holes of the universal mounting bracket.
20082