Installation Guide User Manual

Publication CNET-IN002B-EN-P - June 2010 69
Appendix B
Maintain the Cable Strip Tool
Introduction
This appendix provides instructions to perform maintenance tasks on the
cable strip tool, supplied with the ControlNet Coax Toolkit (1786-CTK).
Reverse or Replace the
Cutting Blades
Follow these steps to reverse or change the cutting blades.
1. Use a screwdriver to lift the memory blade holder and swing it back.
2. Slide the memory blade cartridge out of the strip tool.
ATTENTION
Use care when using the cable strip tool to avoid
personal injury.
20182-m