QUICK START CLASSIC PLC-5 PROG Instruction Manual

2–4 Set up the Hardware

Publication

178510.3 - October 1996

Install the Power Supply

Locking

Bar

20619-M

Set

the jumpers on

the back side of the

power supply like this:

Connect the power cord to the 120V ac

connector of the power supply module.

Install the power supply in the chassis

and snap the modulelocking bar over

the modules.

This

side plugs into connector on the module.

insert wire

here

place tool here

insert wire

here

place tool here

For more information, see the Redundant Power Supplies

(1771-P4R, -P6R) Installation Data, publication number 1771-2.166.