QUICK START CONTROLNET PLC-5
Publication
1785-10.6 – August 1997
Chapter 1
Introduction 1–1. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Identify the Processor’
s Front Panel Components
1–1. . . . . . . . . . . . . .
Check Y
our Components
1–2. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Chapter 2
What Y
ou’ll Be Doing in This Chapter
2–1. . . . . . . . . . . . . . . . . . . . . .
Configure the I/O Chassis 2–2. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Ground the I/O Chassis 2–3. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Install
the Power Supply
2–4. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Install the PLC-5 Processor 2–5. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Powerup the System 2–6. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Install
the I/O Modules
2–6. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Connect
the Personal Computer to the PLC-5 Processor
2–6. . . . . . . .
Chapter 3
Install
the Software and Set Up the Programming System
3–1. . . . . . . .
Start
the Programming Software
3–1. . . . . . . . . . . . . . . . . . . . . . . . . .
Power Up the System 3–1. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Chapter 4
Using
This Chapter
4–1. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Using
the General Status Indicators
4–1. . . . . . . . . . . . . . . . . . . . . . .
Using
the ControlNet Status Indicators
4–3. . . . . . . . . . . . . . . . . . . . .
Using the DH+/RIO Status Indicators 4–5. . . . . . . . . . . . . . . . . . . . . . .
Monitoring
ControlNet Configuration and Status
4–6. . . . . . . . . . . . . . .
Appendix A
Table of Contents
Before You Begin
Set Up the Hardware
Set Up the Software
Troubleshoot the Processor
System
Processor Specifications