User Manual Owner manual

ControlNet I/O MapEntry Status Words
Appendix D
and Error Messages
D-4
Possible Corrective Action(s)Explanation / Possible Cause(s)Error Message
Hex.
Code
Decimal
Code
65527
0xFFF7
MODULE TIMED OUT
The node or slot contains the wrong
module type
Insert the proper module in the correct slot of
the target node
An incorrect module type was
entered in the map table
Enter the correct module type in the map
table entry
65529 0xFFF9
COMM ERROR CAUSED LOSS OF DATA
A communication error between the
module and adapter caused data to
Make sure that the proper module is properly
seated in the correct slot of the target node
odu e a d adap e caused da a o
be lost
Make sure that the correct module type is
entered in the maptable entry
65530 0xFFFA
MODULE DECLARED INVALID LENGTH
The node or slot contains the wrong
module type
Insert the proper module in the correct slot of
the target node
An incorrect module type was
entered in the map table
Enter the correct module type in the map
table entry
65531 0xFFFB
READ DATA INVALID
The node or slot contains the wrong
module type
Insert the proper module in the correct slot of
the target node
An incorrect module type was
entered in the map table
Enter the correct module type in the map
table entry
65532 0xFFFC
WRITE DATA INVALID
The node or slot contains the wrong
module type
Insert the proper module in the correct slot of
the target node
An incorrect module type was
entered in the map table
Enter the correct module type in the
maptable entry
65533 0xFFFD
DATA TABLE TOO SMALL
The processor data table is too
small
Increase the size of the data table to
accommodate the transfer length