User Manual Owner manual

Chapter 3
Configuring Your ControlNet System
3-11
Do this:If you want to:
change a module's idle action
i.e., the action that it takes
when it becomes idle
1. Move the cursor to the module's Idle Action field
2. Press
[F10]—Toggle Entry to toggle between:
•
Resetto change all outputs to zero
•
Hold Lastto maintain all current output values
•
Safeto change all outputs to userspecified fail-safe values
change a module's fault action
from idlei.e., the action that
it takes when it faults from idle
1. Move the cursor to the module's Fault Action From Idle field
2. Press
[F10]—Toggle Entry to toggle between:
•
Idleto use the idle action
•
Faultto use the fault action
apply pending edits and return
to the ControlNet I/O Mapping
(Edit) screen
Press [F1]—Accept Edits
go back to the ControlNet I/O
Mapping (Edit) screen
Press [F2]—Map Edit or [Esc]