User Manual Owner manual

Chapter 2
Planning to Use Your ControlNet
PLC5 Processor
2-16
If they fit and are:
Can be run on a
PLC5/20C or
5/40C channel:
On channel:Archived from a:
Program files
①
for this process:
I/O
• PLC5/20E
• PLC 5/40E
• PLC5/60L
• PLC 5/80E
2
1A or 1B
performed by remote I/Oyou must make these
changes manually by reprogramming
⑤
I/O
• PLC5/40E
• PLC5/40L
• PLC5/80E
2
performed by the ControlNet networkyou must make
these changes manually by reprogramming
③④⑤
①
These include processor files, datatable files, and port configurations.
②
If you do not update the program, the ControlNet processor will fault.
③
You must change blocktransfer instructions for the ControlNet system from the standard block transfer read (BTR) and block transfer write (BTW)
instructions to scheduled transfers or to unscheduled CIO instructions.
④
You must edit nonControlNet PLC5 programs containing references to the I/O Status File for use with I/O connected via the ControlNet network.
Information regarding ControlNet status is stored in a separate data file that you specify through the 6200 PLC5 Programming Software.
⑤
If you do not update the program, the datatable locations corresponding to the missing" I/O devices will not be updated.