User Manual Owner manual

Chapter 1
Installing Your ControlNet PLC5 Processor
1-19
Important: Follow these guidelines:
When Channel 0 is configured for RS-422A compatibility, do not use
terminating resistors anywhere on the link.
When Channel 0 is configured for RS-422A (compatible) and RS-423,
do not go beyond 61 m (approximately 200 ft). This distance restriction
is independent of the transmission rate.
DH+ Programming Cables
When using this communication card: Use this cable:
1784KT, KT2
• 1784CP6
• 1784 CP with 1784 CP7 adapter
1784KL, KL/B
• 1784CP with 1784CP7 adapter
• 1784CP8 adapter
1784KTK1 1784CP5 with 1784CP7 adapter
1784KTx, KTxD 1784CP13
1784PCMK
• 1784PCM6
• 1784PCM5 with 1784CP7 adapter
Remote I/O Cables
Use 1770-CD or cable for remote I/O. See page 1-12 for more
information.
ControlNet Cables
Several types of RG-6 quad-shield cable may be appropriate for your
ControlNet installation—depending on the environmental factors
associated with your application and installation site.