User Manual Owner manual

Chapter 1
Installing Your ControlNet PLC5 Processor
1-16
You can connect a programming terminal to a ControlNet PLC-5
processor via a:
DH+ connection
serial channel
ControlNet connection
DH+ Connection
To attach a programming terminal to a ControlNet PLC5 processor using a DH+ connection:
If you use this card
to access a DH+ link: Use cable:
1784PCMK G 1784PCM6
G 1784PCM5 with a 1784CP7 adapter
1784KT, KT2 G 1784CP6
G 1784CP6 with a 1784CP7 adapter
G 1784CP8 adapter
1784KTx, KTxD 1784CP13
Programming Terminal
PLC5/40C
Processor
BATT
CH 0
DH+ Link
Programming Terminal
PLC5/20C
Processor
DH+ Link
Serial Channel
Programming Terminal
To program the processor using Channel 0, configure the channel for RS232C using DF1
pointtopoint protocol.
PLC5/40C
Processor
BATT
CH 0
PLC5/20C
Processor
Programming Terminal
If your programming
terminal has a: Use cable:
9pin serial port 1784CP10
25pin serial port 1784CP11
Connecting a
Programming Terminal