User Manual Owner manual

Index
I–4
copying node information to a new
address, 35
defining local rack characteristics, 33
deleting a module or message, 39
deleting a node from the node list,
35
deleting all modules and messages,
39
deleting all nodes from the node list,
35
editing 1794 I/O module action, 310
editing ControlNet I/O mapping, 36
editing node information, 34
editing the ControlNet
nodeinformation configuration,
34
entering the length of cable between
repeaters, 34
entering the number of coax repeaters,
34
entering the number of fiberoptic
repeaters, 34
inserting an entry at an unused slot or
message address, 39
inserting nodes into the node list, 35
manually entering the amount of
information received from a
module or message, 37
manually entering the amount of
information sent to a module or in
a message, 37
manually entering the amount of
information to be stored in the I/O
configuration file for a module,
38
manually entering the destination file
for information received from a
module or message, 37
manually entering the file for storing
the I/O configuration needed for a
module, 38
manually entering the source file for
information sent from a module or
in a message, 37
matching the processor and ControlNet
configurations, 32
moving a node description to a new
address, 35
specifying the Data Input File (DIF),
36
specifying the Data Output File (DOF),
36
specifying the Default Configuration
File, 36
specifying the Diagnostics File, 34
specifying the I/O Status File, 36
specifying the maximum scheduled
node address, 35
specifying the Network Update Time
(NUT), 34, 37
specifying the number of coax
repeaters, 34
specifying the redundancy
characteristic of the ControlNet
media, 35
viewing the maximum percent of
scheduled bandwidth, 35
viewing the number of scheduled I/O
maptable entries indicating data
transfers to and from the
processor, 37
viewing the percent of scheduled
bandwidth used in the worst case,
37
viewing the percentage of the Data
Input File (DIF) being used, 37
viewing the percentage of the Data
Output File (DOF) being used,
37
configuring nodes, 27, 214
locating additional information, iii
monitoring, 51
viewing a 1794 system's fault action,
511
viewing a 1794 system's fault action
from idle, 511
viewing a 1794 system's idle action,
511
network maintenance, 23
network update cycle, what happens in,
23
scheduled operations, 23
selecting devices to connect, 213
setting the switches, 111
troubleshooting, 51
unscheduled operations, 23
using ControlNet PLC5 processors in,
213
ControlNet WHO ACTIVENetwork Status
screen, fields
Bad Frames Received, 519
Errors / 100,000 FramesChan A, 519
Errors / 100,000 FramesChan B, 519
Good Frames Received, 519
Node, 519
Total ErrorsChan A, 519
Total ErrorsChan B, 519
D
Data Input File
description, 29, 210
specifying, 36