Installation Instructions Owner manual

1 Publication 1784-IN008A-EN-P - November 2000

Installation Instructions

Synchronization Cable

(Catalog Number 1784-PMCSY4)

Up to four (4) 1784-PM02AE cards may be installed in a single

computer provided there are enough PCI Bus slots available. A sync

cable is required to keep the cards synchronized. This is a ribbon

cable with four connectors that fit to the cards.

The cable is a 28AWG, 7/36 stranded, ribbon cable with centerline

spacing of .05mm. The connectors are 10 way ribbon cable receptacles

of gold over nickel.

Figure 1 1784-PMCSY4 Cable

The 10 pin connector attaches to the card at the opposite edge from

the PCI Bus connection.

IMPORTANT

The connectors should be fitted the same on all

cards, as the mating connector is not polarized.

60 mm 60 mm 60 mm

10 pin ribbon connectors

PAGE 1
Installation Instructions Synchronization Cable (Catalog Number 1784-PMCSY4) Up to four (4) 1784-PM02AE cards may be installed in a single computer provided there are enough PCI Bus slots available. A sync cable is required to keep the cards synchronized. This is a ribbon cable with four connectors that fit to the cards. The cable is a 28AWG, 7/36 stranded, ribbon cable with centerline spacing of .05mm. The connectors are 10 way ribbon cable receptacles of gold over nickel.
PAGE 2
Figure 2 Side View of the 1784-PM02AE Card Sync cable connection Connects to back of computer Cable connection to termination panel Connects to PCI Bus Publication 1784-IN008A-EN-P - November 2000 2 PN 957395-27 © 2000 Rockwell International Corporation. Printed in the U.S.A.