Configuration Manual Owner's manual

Publication 1784-UM003A-EN-P – June 2003
SoftLogix Controller 21
Stop Bits
The actual number of stop bits per character. Choose from 2 (ASCII only) or 1
(default).
Control Line
Choose the type of handshaking you wish to use during communications. The
choices available to you vary, depending on the protocol you have selected:
Continuous Carrier
Check this box if you wish to use Half Duplex communication with
continuous carrier. This checkbox is disabled if you have chosen something
other than Half Duplex communication, or if you have chosen Master as your
protocol. By default, this option is unchecked when enabled.
RTS Send Delay
Enter the time (in ms) to delay transmitting the first character of a message
after turning on the RTS line. The default value is 0.
RTS Off Delay
Enter the time (in ms) to delay turning off the RTS line after the last character
has been transmitted. The default value is 0.
For this mode: And this protocol: Choose from:
User ASCII No Handshake (default)
Full Duplex
Half Duplex
System Point-to-Point No Handshake (default)
Full Duplex
Slave No Handshake (default)
Half Duplex
Master No Handshake (default)
Full Duplex
Half Duplex