Configuration Manual Owner's manual

Publication 1784-UM003A-EN-P – June 2003
236 Configuring a Kinetix 6000 Drive
Refresh
Click on this button to refresh the tab with new data from the module.
If you are online in Program, Remote Program or Remote Run mode, and this
controller is the owner controller, and you have changed the module’s
configuration in the software, then when you click the Apply or the OK
button, the information is automatically sent to the controller. The controller
tries to send the information to the module (if the module’s connection is not
inhibited). If you don’t click Apply, your changes are not sent to the controller.