User Manual

Pre-installation Procedures 2-3
Publication 1784-UM519C-EN-P - September 2006
Windows 95/98 Operating Systems
Install the RSIPCMK driver if you are using:
• Software compatible with the Windows 98 operating system, such as:
– A.I.- Series, RSLogix 5 software
– RSLogix 500 software
– RSLogix 5000 software
– PanelBuilder software
– INTERCHANGE software, version 6.0.5 or later
– WINtelligent LINX software, version 5.20 or later
– RSLinx software
– 6200 PLC- 5 or 5/ 250 controllers with INTERCHANGE or RSLinx software
• Windows 98 operating system
Only software products that communicate through RSLinx are supported on
the Windows 98 operating system.
Refer to Chapter 3 for specific instructions on the Windows 95/98 operating
system.
Windows NT Operating System
The Windows NT driver for the PCMK card is built into RSLinx software, version 1.7
or later. Rockwell Automation has published detailed instructions for configuring
this driver. Refer to Chapter 4 for specific instructions.
Windows 2000 Operating System
If you are using the Windows 2000 operating system, the driver ships with RSLinx
software version 2.2 or later. Refer to Chapter 5 for specific instructions.