User guide

5-4 Install and Use the Driver for Windows NT
Publication 1784-IN029C-EN-P - June 2001
Unicore/Touchstone Software’s CardWare
If you have Unicore/Touchstone Software’s CardWare, you must upgrade to version
2.11 or later.
Do not use the Allen-Bradley 1784-PCD card icon in the Control Panel to assign
memory and interrupt resources. The Unicore/Touchstone Software PC card
controller assigns these resources for you automatically.
For more information, contact Touchstone or Unicore:
Touchstone: Internet: www.touchstonesoftware.com
Unicore: Internet: www.unicore.com/products
Install the Driver
To install the driver, do the following:
1. To verify that an earlier version of the driver is not installed, click
Start Settings Control Panel. Double-click the Add/Remove
Programs icon. Click the Install/Uninstall tab. Scroll down the list to
ensure the driver is not listed.
2. Shut down the PC.
3. Insert the PCD card into your computer as described in Chapter 7.
4. Start Windows NT.
If you have Phoenix/Softex’s Card Executive on your system, you may
see the following message:
If: Then:
the driver is installed remove it. Refer to Remove the Driver on
page 5-8.
the driver is not installed click OK or Cancel.
If: Then:
you have third-party plug-and-play card
controller software
refer to the bulleted list following this table
you do not have third-party plug-and-play
card controller software
go to step 5 on page 5-6