User manual

Running Diagnostics A-5
1784-6.5.27 - September 1997
Start Diagnostics
1. From the introductory screen, press .
You see the main menu:
Press F1 to start the diagnostics. The information displayed is from the
KTXDIAG.INI file in the KTXDIAG directory. Each time you run the
diagnostics, the program looks for this file, not for the current PKTx
settings. If this file is not found, default settings are used.
To update the KTXDIAG.INI file, use the Online Configuration (F2)
option.
2. Use the decision table below.
To Press this key Go to
Define a PKT
x card to test (Online
Configuration)
F2 page A-6
Test the computer’s ability to communicate
with the PKT
x card
F4 page A-9
Run the PKT
x card’s self-diagnostics F5 page A-9
Test PKT
x dual port communications F7 page A-10
Exit diagnostics F10 N/A
Note: the F3 (M16 Test) and F4 (Test computer) options are not necessary for the PKT x card.
F1
F10 allows you to
clear any
messages on the
screen.