User manual

4-14 Connecting the Interface Card
1784-6.5.27 - September 1997
Figure 4.2 Communicating to a single SLC using a
point-to-point DH-485 link
To connect an SLC family processor to the PKTx card, you:
1. Connect the termination resistor end of the CP14 cable to the PKTx card
2. Connect the RJ-45 connector directly to the phone-jack connector on
the front of the SLC processor
To
1784-PKT
x Card
30173
SLC Controller
1784-CP14 Cable
Personal Computer
20222-A
6-pin Phoenix connector with
switchable termination resistor
RJ-45 connector
1784-CP14 cable
20222a