User manual
Installing the Card Inside the Computer 3-3
1784-6.5.27 - September 1997
Inserting the Card
To insert the card inside the computer:
1. Follow the card handling instructions on page P-3.
2. Make sure you have set correctly the jumpers on the card. (See chapter
2.)
3. Turn off power to the computer.
Important: If you disconnect the ac power from the computer, you lose
the chassis ground. Electrostatic damage (ESD) protection is
lost.
4. Loosen the expansion slot screw and remove the outside retaining
bracket (ORB).
5. Insert the PKTx card into the edge connector and tighten the expansion
slot screw on the PKTx ORB.
6. Restore power to the computer.
7. Run PKTx diagnostics from the PKTx Utility disk now. See appendix A.
8. Start the application software.
9. Make sure that the PKTx jumper settings are compatible with your
operating system. If not, your jumper settings will need to be changed.
10.Turn off power to the computer.
11. Replace the CPU cover.